TRIPLE-MAG- Komunica reinforced magnet base Maximum grip
Diameter: 3pcs x 9cm
Connector: SO-239
Cable RG-58 (5mts)
Special WIDE BAND antenna for HF
-
Tx: 7-30 MHz + 50MHz (50-54MHz)
-
Rx: 3-70 MHz
Your Bazoka-Pro is a Pre-tuned antenna
Add to compare0
Add to wishlist
-
Tx: 7-30 MHz + 50MHz (50-54MHz)
-
Rx: 3-70 MHz
-
Impedance: 50 Ω
-
V.S.W.R: less than1.5
-
Length: 1.22m
-
Weight: 680g
-
Connector: PL-259
-
Maximum Power: 120W (SSB), 40W (FM)
Your Bazoka-Pro is a Pre-tuned antenna
For optimum operation, no adjustment is necessary.
You can only make a fine adjustment on the 7Mhz band, slightly sliding its upper rod until you get the right resonance.
Recommendations:
-
Remember that your Bazoka-Pro is a mobile broadband type antenna with small dimensions, so that the antenna propagation efficiency can be reduced to 1/10, due to its Broadband structure
-
The use of antenna coupler is recommended.
-
Be sure to use a large bracket, according to the size of this antenna, since your Bazoka-Pro is a heavy and large antenna.
-
Your Bazoka-Pro can be installed both in a vehicle, as on a metal balcony or other surfaces.
-
Before installing your Bazoka-Pro in the vehicle, make sure that the antenna is properly connected to the vehicle chassis to obtain a good mass.
-
We suggest experimenting, to get the best performance from your Bazoka-Pro. For this it is interesting to change the location of the antenna in your car and find the place where the SWR is lowest. Certainly, the location of the antenna in the car directly affects its performance, so we suggest you consider this recommendation and do not fix the antenna to the center of the roof of your vehicle. You should experience other angles and even if possible, use other types of brackets.
-
Always operate your Bazoka-Pro as a portable antenna, we suggest you try adding to your Bazoka-Pro 4 radials (or as many as possible) between 8 and 10 meters long each. Another option is to connect the antenna mount a good grounding by means of a cable of 6mm2 section. Both solutions are very good for improving the signal rate.
EAN:8435757701030
Related Products
It includes:
1 Extendable Telescopic Tripod 4 sections in Aluminium
1 Galvanized Iron Sheet Plate with Professional Base SO-239
2 Kits of ground not tuned x 4 wires of 3m prepared for fixing by picks
1 pig-tail 5.5m of low-loss cable RG-58 for connecting the base (sheet plate) to the transceiver antenna connector (PL-259).
Various screws
16 other products in the same category:
Hinged Mobile Ham Antenna.
Solid design, ideal for outdoor & 4x4
Komunica Multiband Antenna: Tetra 380 ÷ 410 MHz + ACTIVE GPS / GNSS / GALILEO + AM-FM
Mobil antenna 134-174MHZ, VAR1200MM, strong spring, PL.
Innovative Komunica® HF-PRO-2-PLUS-T portable Wide Spectrum antenna:
3.5MHz (by included coil) + 7 / 30MHz + 40MHz + 50MHz + 70MHz + VHF
Maximum robustness, super-light and ultra-compact size:Mesurement: 29cm disassembled and 270cm maximum extension.
Ideal QRP, SOTA, etc. by telescopic tripod, magnetic base reinforced, etc AVAILABLE EXCLUSIVELY THROUGH OUR EUROPEAN DEALERS
Professional Multiband Antenna:
130 ÷ 230MHz (Cutting Diagram)
or 380 ÷ 470 MHz (Cutting Diagram) + GPS-GNSS-GALILEO
Multiband professional antenna
TETRA (380: 430MHz) + GPS + GSM + UMTS + LTE
Twin Band VHF/UHF mobile with Flex System for EASY folding
Maximum recommended inclination 45º
Hinged Mobile Ham Antenna
Multiband Antenna
380 ÷ 470 MHz / GPS-GNSS-GALILEO
Mobile antenna 5/8, TETRA + GPS with 28º, 5m cable
Frequency Range: 7-30/50MHz
Type: Portable (loaded 1/4 wave on HF & true 1/4 wave on 50Mhz)
Maxim Power Level: 130W (SSB)
TETRA & UHF 380 ÷ 430MHz
Professional mobile antenna with 74º tilt angle.
Installation version
VHF 130 230 MHz
UHF 385 520 MHz
Adjustment by means of cutting diagram
Includes extension of 5mt coaxial cable
Multiband Antenna
LTE / 2.4GHz - 5.8GHz / ACTIVE GPS-GNSS-GALILEO
Customers who bought this product also bought:
Antenna for walkie 50-144Mhz. 1/4 wave, 430Mhz. 1/2 wave, 1200MHZ, , RX 120,150,300,800 Y 900 MHZ,0 dbi(145), 2.15dbi(430), 5.5dbi(1200), 10W, 500MM. SMA
Base Type Rotating ball-socket carrier and PL connector
Maximum adhesion9 cm diameter, extra-flatSO-239 connectorRG-58 cable (5mts)
Flexible whip and best performance
Frequency: 144/430 MHz
Impedance: 50 Ω
Max. Power: 10 W
Lenght: 20,50 cm
Weight: 29,4 gr
Connector: SMAF (SMA Female)
Polarized Power Cable with 4-Pin Connector and 3m Fuse Holder.Compatible with the following equipment:
IcomIC-7000, IC-7200, IC-7300, IC-7410, IC-7600, IC-9100
KenwoodTS-480, TS-480SAT, TS-480HX (requires 2 connections), TS-590S
YaesuFT-450, FT-450D, FT-950, FT-991/A, FT-2000, FTDx-3000, FTDX-101MP
AlincoDXSR8T
Other brands with 4-pin Molex connector
Compatible with:
VERTEX / YAESUFT-50 / FT-60 / FT-10/FT-11/ FT-250/FT-40/FT-60VX-VX1R/2/3/5/10/VX-110/VX-150/ 180/ VX-300/400 VX-5R/VXF-1
EVX261
SWR & Watt meter,1.8-160/140-525 MHz. 5/20/200W
High quality Micro-earphone provides absolute audio clearity, with ear hook, coil cord and metal clip available to rotate by 360º
Antenna for walkie UHF, 430-470 MHz, 50W, for MOTOROLA Connector
Impedance 50 OhmRelation: 1:1Power: 500WLength: 12cm
Specific Connector Base Trunk B-01, B-02, Bl-12
It includes:
1 Extendable Telescopic Tripod 4 sections in Aluminium
1 Galvanized Iron Sheet Plate with Professional Base SO-239
2 Kits of ground not tuned x 4 wires of 3m prepared for fixing by picks
1 pig-tail 5.5m of low-loss cable RG-58 for connecting the base (sheet plate) to the transceiver antenna connector (PL-259).
Various screws
Magnetic base super-grip
PL-259 connector
Compatible with:
MOTOROLA
CP-040/ 140/ 150/ 200
EP-450 /GP3188/3688
PR400 /DP-1400